User Manual

Message Meaning
This feature will be supported in a future software release. This feature will be supported in a future software update.
This item is read only!
You cannot modify this item. This message appears if you
attempt to change a Factory preset title.
Too many Monitor Sources! Max. 8 sources can be assigned.
Too many sources have been selected for monitor input. (Up
to eight sources can be assigned.)
Total MY slot power capability exceeded! Remove cards from
unit XX
Normal operation is not possible because the power at the
MY slots exceeds the maximum power allowed. Remove the
MY cards from unit XX. For information on the maximum
number of MY cards that can be used, please visit the
Yamaha Pro Audio website at:
http://www.yamahaproaudio.com/
TWINLANe total cable length too long (HY SLOT X)
The total length of cables on the TWINLANe network (HY slot
X) is too long.
TWINLANe clock master not found!
The TWINLANe clock master cannot be found. One DSP
engine in the system must be assigned as the word clock
master.
TWINLANe optical receiver input power margin low [XXX]
The power of the optical receiver for communication on the
TWINLANe network is getting low. Check the cable integrity
and connection, and clean the connection.
TWINLANe: ring connection open! [XXX] Check cable
connection.
The system detected disconnection of the ring connection on
the TWINLANe network. Check the cable integrity and
connection.
TWINLANe: wrong cable connection!
The system detected an incorrect TWINLANe cable
connection. Make sure that the ring connection is proper by
connecting the cables in the order of IN-OUT.
Unassigned encoder You operated an encoder for which no function is assigned.
Under a synchronization. Currently synchronizing.
Unit Fan has Malfunctioned! The fan of the R-series unit has malfunctioned.
Unit ID Duplicated! There are duplicate UNIT IDs on the Dante audio network.
Unsupported file format!
An unsupported file format was detected and the file failed
to load.
Unsupported USB storage format! The USB storage format is incorrect or unsupported.
USB over-current error! Disconnect USB device.
An excessive current was detected at the USB port. Remove
the USB device connected to the USB port, and check the
port for abnormalities.
USB recorder busy! Operation aborted
The two-track USB recorder is currently processing data. The
latest operation was aborted.
USB recorder: Cannot edit comment. No ID3 tag in the file.
No ID3 tag exists in the file, and the system failed to edit the
comment.
USB recorder: Max. number of audio files exceeded!
The maximum number of song files allowed has been
exceeded.
USB recorder: Metadata edit failed Metadata for the song file failed to be edited.
USB recorder: Metadata successfully changed Metadata for the song file was edited.
USB recorder: Playback stopped due to slow memory access!
Playback was interrupted due to insufficient access speed to
the USB storage device.
USB recorder: Recording stopped due to slow memory
access!
Recording was interrupted due to insufficient access speed
to the USB storage device.
1009
Messages > Messages