User Manual

Shut down (power-off procedure)
Before you shut down the control surface, Yamaha recommends that you store the current status to scene
memory. If you change the connection status of the components after the power is turned off, some settings,
such as patching, may be altered when you turn the power on again. For instructions on storing scenes, see
“Storing a scene” on page 313.
NOTICE
(
If you turn off the power to the control surface without following the shutdown procedure, data inside the built-in storage
(including the current memory) may be damaged. Be sure to perform the shutdown procedure to turn off the power to the
control surface.
1 Press the [SYSTEM] key for two seconds or longer. A message will ask you to
confirm the shutdown operation.
2 To shut down the control surface, press the OK button. To cancel shutdown, press
the CANCEL button.
3 Wait until the LEDs on the panel turn off, the touch screens go dark, and the POWER
indicator lights orange.
4 Turn off both power switches A and B on the rear panel.
CAUTION
(
If you plan to turn on the power to the control surface again, wait at least five seconds before switching the power on.
Otherwise, the unit may malfunction. Even when the power switches are turned off, a small amount of current still flows
through the unit. If you plan not to use the unit for a long period of time, remove the power cords from the AC outlets.
NOTE
You can shut down the control surface by assigning the Console Shutdown function to a USER DEFINED key or GPI IN.
109
Basic operations on the panel > Shut down (power-off procedure)