User Manual

Channel name area
Press the channel name area to switch the selected channel/parameter on the screen. If you switch fader
layers, the indication in this area will reflect the change in layer selection. In this way, you can access any
channel on screen.
Channel name
NOTE
Switching layers will not affect the selected channel/parameter on the screen. The 12-channel group displayed on the OVERVIEW
screen will change. However, unless you press the channel name area, the selected channel/parameter on the screen will remain
unchanged since your last press of the [SEL] key(s). If you want to switch the selected channel/parameter on screen at the same time
you switch layers, you can configure this arrangement by selecting [FADER BANK] > [SEL] LINK in the Preferences settings.
When you use a screen encoder to control an EQ or dynamics parameter in the SELECTED CHANNEL VIEW
screen, the corresponding parameter and its value will appear in the upper part of the channel name area.
EQ
Dynamics
MIX/MATRIX SENDS
The following functions will be displayed.
* If ALTERNATE FUNCTION is assigned to a USER DEFINED key, pressing the channel screen encoder
repeatedly will turn the function on and off.
For the SENDS function, rotate the screen encoder to set PRE or POST.
You can also turn the function on or off by pressing the screen encoder while holding down the [SHIFT] key.
120
Basic operations on the panel > Viewing a touch screen