User Manual

Recalling a preset from a library
This section describes how to recall a preset from a library.
1 Press the LIBRARY tool button.
The corresponding Library screen (Recall) will open.
2 Rotate the corresponding screen encoder to select the preset number you want to
recall.
3 Press the RECALL button.
The selected preset data will be loaded and displayed.
NOTE
Some presets selected as the recall source may not be recalled into the currently-selected item.
The following restrictions apply for each library:
(
Channel libraries
In the OUTPUT CH library, if the type of channel selected in the list does not match the type of channel
selected as the recall destination, the “CONFLICT” indicator will appear on the right side of the TYPE
column. You can still recall the preset while the “CONFLICT” indicator appears. However, please note that
parameters that are not included in the recalled preset will be set to default values.
(
OUTPUT EQ library
This library is sub-categorized into three types: output channel EQ, 8BandPEQ (to be mounted to INSERT),
and MONITOR/CUE EQ. If you select a different type of preset than the destination, the “CONFLICT”
indicator will appear. You can still recall the preset while the “CONFLICT” indicator appears. However,
please note that parameters that are not included in the recalled preset will be set to default values or will
remain unchanged.
(
GEQ library
The presets stored in the GEQ library are sub-categorized into two types: 31BandGEQ and Flex15GEQ. If a
31BandGEQ library preset includes gain settings for more than 16 bands, you will be unable to recall it into
Flex15GEQ.
(
USER SETUP library
Setup data created in PM Editor can be recalled only by using PM Editor. Setup data created on the control
surface can be recalled only by using the control surface.
129
Basic operations on the panel > Recalling a preset from a library