User Manual

Pair setting
Adjacent channels can be paired and used as a stereo module.
Input channels
You can pair either odd/even-numbered channels or even/odd-numbered channels. For single input
channels (monaural), the pan level is nominal at the center, and +3 dB at hard left or hard right. For paired
input channels, the balance level is nominal at the center, and +3 dB at hard left or hard right.
MIX buses and MATRIX buses
You can pair adjacent odd/even-numbered MIX buses or MATRIX buses.
NOTE
For information on the parameters that can be linked using the pair setting, refer to the data list.
When MIX buses are paired, the signal flow will change as described below:
CH to MIX
FIX
MIX1- 72
(MATRIX 1- 36)
72
712
1
to MIX 1
ON
to MIX 2- 72
(
same as above )
POST ON
to MIX (FIXED / MIXMINUS )
MONO to MONO
to M
IX 1
to MIX 2
ON
to MIX 3- 72
(
same as above )
POST PAN L
to MIX (FIXED / MIXMINUS )
MONO to STEREO
POST PAN L
POST PAN R
to MIX 3- 72
(
same as above )
to MIX 1
to
MIX 2
ON
to MIX (FIXED / MIXMINUS )
STEREO to STEREO
POST
PAN R
POST ON
POST ON
to MIX 2- 72
(
same as above )
to MIX 1
to
MIX 1
ON
to M
IX (FIXED / MIXMINUS )
STEREO to MONO
135
Basic operations on the panel > Pair setting