User Manual

a
ON button
Switches the Recall Safe status on or off.
b
Popup button
Press this button to access the RECALL SAFE popup window. This button will indicate “PARTIAL” if recall safe applies
only to some of the parameters, not to all channel settings. It will indicate “All” if recall safe applies to all parameters.
If no parameters are specified, it will indicate “OFF.”
SOLO SAFE
1
a
ON button
Turns the Solo Safe function on and off.
MUTE SAFE
1
a
ON button
Turns the Mute Safe function on and off.
TO STEREO field
You can control the stereo balance of the signals sent from the selected channel to the STEREO bus, or the
signals output from the MIX/MATRIX/STEREO buses. The indication varies depending on the selected
channel, as follows.
2
3
1
If the selected channel is an input channel or MIX channel:
Use the PAN knob on the right a to adjust the panning of the signal. Use the TO ST A button b to switch on
or off the signal sent to the STEREO A bus. Use the TO ST B button c to switch on or off the signal sent to the
STEREO B bus.
141
Screen Overview > About the SELECTED CHANNEL VIEW screen