User Manual

MIX/MATRIX SENDS field
1
a
MIX popup buttons (input/MATRIX channels only)
For input channels, each button indicates the level of the send signal sent from the selected channel to the MIX bus.
For MATRIX channels, each button indicates the level of the send signal from the MIX bus to the selected channel.
Press the buttons to recall (roll out) the send parameters to the screen encoders. Press them again to switch the
screen to SEND FROM or SEND TO.
NOTE
If the encoders on the CS-R5 are in channel strip mode, press these buttons to switch the screen to SEND FROM or SEND TO.
On with PRE On with POST
Off with PRE Off with POST
153
Screen Overview > About the SELECTED CHANNEL VIEW screen