User Manual

Routing a signal to the STEREO bus
Follow the steps below to route the input channel signals to the STEREO bus.
1 In the channel strip section on the top panel, press the [SEL] key for the target
input channel.
2 Make sure that the TO ST [A] key in the Selected Channel section is turned on.
If the TO ST [A] key is turned off (its LED is off), press the key to turn it on (the LED lights up).
3 Make sure that the [ON] key for the target input channel is turned on.
If the [ON] key is turned off (its LED is off), press the key to turn it on (the LED lights up).
4 Make sure that the [ON] key for the STEREO A channel on the top panel is turned
on.
188
Quick Guide > Routing a signal to the STEREO bus