User Manual

6 Raise the input channel fader to the appropriate volume level.
At this point, you should be able to hear sound from the speaker system (that is patched to the
STEREO A channel). If no sound is heard, check to see whether the meters are moving in the
METER screen.
If the input meters are not moving
Make sure that signals are being input correctly to the patched input channels.
If the meters are moving but no sound is heard
The output ports (to which the speaker system is connected) might not be patched correctly.
Check the patching status of the output ports.
190
Quick Guide > Routing a signal to the STEREO bus