User Manual

INOUT INOUT INOUT
400 ch
Even if a cable is severed at one point, the signal will be re-routed automatically and communication will
continue without interruption.
In RIVAGE PM system version 2 and later, you can make settings for two TWINLANe networks (MAIN and SUB).
This is convenient if I/O racks are located in numerous places such that eight RPio units are insufficient, or if
you want to divide the administration of a large system for simplicity. The following settings are required in
order to provide the appropriate word clock to the system.
(
Share TWINLANe (MAIN) network between all DSP engines.
(
Connect the TWINLANe (MAIN) network only to HY card slot 1 of each DSP engine, and set the UNIT ID of
the RPio only to M1–M8.
(
Connect the TWINLANe (SUB) network only to HY card slot 2 of each DSP engine, and set the UNIT ID of the
RPio only to S1–S8.
(
Specify MASTER as the “Word Clock”(p.292) of the DSP engine of the lowest UNIT ID in the network, and
specify SLAVE for other DSP engines.
194
Network and Connections > Connecting a TWINLANe network card