User Manual

NOTE
(
Changing the Bay Link setting will clear the position of the selected channel stored in each layer. Once this position data is cleared,
the selected channel (which was already selected at the time of layer switching) will move to the left-most channel in the fader
bank. (Please note that this applies only when FADER BANK SEL LINK is turned on.)
(
If Bay Link mode is changed while DCA channels are being rolled out, the DCA roll-out operation will be canceled.
(
If the Bay Link setting is changed for a bay on which the SET BY SEL button is turned on, SET BY SEL will be turned off.
228
Bay > Bay Link