User Manual

d
DSP popup button
Press this button to access the SYSTEM CONFIG [DSP] popup window, in which you can assign the DSP engine’s MIX
channels, MATRIX channels, and direct outputs to the TWINLANe network, and make settings for the HY slots and MY
slots. In the case of a DSP engine that is the word clock master for any TWINLANe network (Main, Sub, or Console), an
indicator is shown above this button.
In the case of a DSP mirroring configuration, this area will display a button for switching the DSP engine between
active and standby, and DSP popup buttons for two units. In this case, the SYSTEM CONFIG [DSP] popup window that
is opened by the DSP popup button will be valid only for the DSP engine that is selected as the active unit by the
active/standby button.
e
HY CARD SELECT popup button
Press the button to open the HY CARD SELECT popup window, in which you can select an HY card to mount.
f
HY SLOT popup button
Press the button for the mounted card to display the corresponding HY SLOT popup window.
If you press the button while it is blank, the HY CARD SELECT popup window will open to enable you to select an HY
card to mount.
244
System Setup > SYSTEM popup window