Manualshelf

User Manual

ManualsBrandsYamaha ManualsMixerRIVAGE PM series
251252253254255256257258259260
I/O rack settings popup window
This screen contains the following items.
a
I/O rack select popup buttons
These buttons represent the I/O racks that are connected to the system. Press one of these buttons to access a popup
window, in which you can select an I/O rack. The row at the top of the button shows the power supply status of
POWER A and B (green: power on, red: power off). The device icon indicates the status of +48V MASTER (red: on; grey:
off), and also the status of the device (green: normal; yellow: abnormal; red: critical error).
b
Optical reception power status display
This section indicates the power status and readings of the optical receiver for communication on the TWINLANe
network.
Green: Normal
Yellow: Low optical reception power
Red “LOW”: No reception
It also indicates the type of HY cards (MMF:HY256-TL; SMF:HY256-TL-SMF) and the total length of the cables.
c
RY SLOT (1–6) popup buttons
When you press a button, the RY CARD SELECT popup window appears, in which you can select an RY card.
d
MY SLOT (1–2) popup buttons
Press a button to open the MY CARD SELECT popup window, in which you can select a Mini-YGDAI card.
e
HY SLOT (2) popup button
Press the button to open the HY CARD SELECT popup window, in which you can select an HY card.
f
HIGH Fs FORMAT select button
When a Mini-YGDAI card is using high sampling (88.2 kHz, 96 kHz), these buttons select the operating mode as
DOUBLE SPEED, DOUBLE CHANNEL, or SINGLE for IN and OUT respectively.
NOTE
This setting will be ignored if you try to specify a mode that the MY card does not support.
g
WITH RECALL button
Turn this button on to apply the scene data to the HA device and output patches when a scene is recalled. If you do
not want to recall the HA gain setting, turn this button off. (For example, if the monitor console is controlling the HA,
turn this button off at the FoH.)
h
Parameter settings popup buttons
Press a button to open a popup window, in which you can set the parameters of each card.
252
System Setup > I/O rack settings popup window