User Manual

Editing the internal parameters of the RY16-ML-SILK
76
5
1
4
98
!
#
2
$
%
@
)
3
This screen contains the following items.
a
Patch indication
Indicates the channel that is patched.
b
+48V button
Switches phantom power (+48V) on or off.
c
A.GAIN knob
Indicates the HA analog gain setting. Use the screen encoder to adjust the value. If gain compensation is on, an
indicator shows the analog gain position at the time that gain compensation was turned on.
d
Meter (Pre GC)
This meter indicates the level of signals after passing through analog gain (before GC).
e
Meter (channel input)
This meter indicates the level after passing through GC (before D.GAIN).
f
GC (GAIN COMPENSATION) button
Switches the gain compensation on or off for that channel.
g
PHASE button
Switches the phase of the input signal.
NOTE
This is a parameter within the I/O rack. It is different than the Ф parameter within the channel module of the control surface.
261
System Setup > Editing the internal parameters of the RY16-ML-SILK