User Manual

SYSTEM CONFIG Offline settings

You can make system settings using the control surface by itself, without connecting a DSP engine or I/O

rack. The procedure for offline settings is described below.

1 “Mounting an I/O rack (offline)”(p.279)

2 “Specifying the type and number of cards (Offline)”(p.282)

3 Assigning channels to the TWINLANe network

4 “Editing the internal parameters of each component”(p.260)

5 “Dante audio network settings”(p.299)

NOTE

If the settings made while offline differ from the settings of the actual device when the actual device is connected, the settings of the

actual device will take priority over the offline settings, and will be applied to the system.

278

System Setup > SYSTEM CONFIG Offline settings