User Manual

f
HIGH Fs FORMAT select buttons
When a Mini-YGDAI card is using high sampling (88.2 kHz, 96 kHz), these buttons enable you to select the operating
mode as DOUBLE SPEED, DOUBLE CHANNEL, or SINGLE for IN and OUT respectively.
NOTE
This setting will be ignored if you try to specify a mode that the MY card does not support.
g
WITH RECALL button
Turn this button on to apply the scene data to the HA device and output patches when a scene is recalled. If you do
not want to recall the HA gain setting, turn this button off. (For example, if the monitor console is controlling the HA,
turn this button off on the FoH.)
h
Parameter settings popup buttons
Press a button to open a popup window, in which you can set the parameters of each card.
i
TWINLANe assign buttons
When you press a button, the number of channels used by the selected slot will be assigned to TWINLANe (or the
assignment will be canceled). For an HY slot, a window in which you can make settings in 16-channel units will
appear.
NOTE
Bandwidth for an I/O rack can be assigned to the TWINLANe network only for the DSP engine that is the word clock master of
the system. If the assignment is unavailable, the button will be disabled.
You must assign the number of channels required for input signals (that is, signals output to the TWINLANe network). You do
not need to assign bandwidth to an RY slot that has an RY16-DA card installed, nor to a slot that has an output-only MY card
installed.
j
REVERT ALL button
If you press this button, all changes in channel assignments that you made up to that point will be canceled, reverting
to the state prior to the changes.
k
APPLY button
If you press this button, the channel assignment changes you made will be applied to the TWINLANe network.
l
Number of TWINLANe channels
Indicates the total number of channels currently used by the TWINLANe network.
m
ROUTING MODE switch button
Press this button to open a popup window, in which you can switch the routing mode for HY slot 2.
ROUTING MODE switch popup window
284
System Setup > I/O rack settings popup window