User Manual

Remotely controlling an I/O rack
You can control an I/O rack that supports remote control and is connected to the Dante connector.
Supported models are indicated by a remote control icon. Up to 24 units can be mounted per Dante network
card. In addition, up to 48 units can be controlled, and a maximum of 128 channels per device can be
controlled.
1 Press the SETUP button on the menu bar to access the SETUP screen.
2 Press the SYSTEM CONFIG button to access the SYSTEM CONFIG popup window.
3 Press the HY SLOT tab (for the slot in which the Dante network card is mounted).
The “HY SLOT window”(p.320) appears.
NOTE
On the CSD-R7, press the HY SLOT2 tab to access the HY SLOT2 screen.
4 Press the I/O rack select button for an HA-equipped I/O rack that is mounted.
The “DANTE I/O DEVICE [I/O] screen”(p.322) appears.
5 Remotely control the HA of the I/O rack.
Control the HA of the I/O rack from the Selected Channel section, the OVERVIEW screen, or the
SELECTED CHANNEL VIEW screen. When you press the panel’s [SEL] key, the signal indicator of
the I/O rack port to which the corresponding channel is patched will flash. Operations can also
be performed from the I/O DEVICE popup window that appears when you press the HA display
area of the I/O rack.
318
System Setup > Remotely controlling an I/O rack