User Manual

Buttons Send Point
POST FADER Immediately after the fader
POST ON Immediately after the [ON] key
e
FOLLOW setting buttons
Enable you to select for each channel whether the signal sent to the MIX/MATRIX bus will follow the ON/FADER/DCA
settings regardless of the send point. These buttons correspond to the following parameters.
Buttons Setting
ON FOLLOW ON
FADER FOLLOW FADER
DCA FOLLOW DCA
f
SEND TO [+]/[−] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for one channel at a time.
g
SEND TO [<<]/[>>] buttons
Enable you to select the MIX/MATRIX bus channel as the signal destination for 12 channels at a time.
329
System Setup > SEND POINT page