User Manual

Mix minus
This function removes only the signal of a specified channel from the signal that is sent to the MIX/MATRIX
bus. By using this, you can quickly send to a performer or announcer a monitor signal that omits only the
voice of that person. You can make mix minus settings ahead of time, and then specify the OWNER channel
to associate an announcer’s mic (input channel) at their location with their monitor (mix minus bus).
1 Press the SETUP button to access the SETUP screen.
2 Press the BUS SETUP button.
The “BUS SETUP popup window”(p.332) appears.
3 Press the BUS SETUP tab.
4 Press the MIX MINUS button.
NOTE
(
The send level of the signal sent from the selected OWNER channel is lowered to -∞ dB.
(
The send levels of all signals sent from input channels other than the selected channel are set to nominal level (0.0 dB).
(
Also, send to the send-destination bus is turned on, and the send point is switched to POST.
(
For a stereo input channel, the send levels of both signals sent from the two channels are lowered to -∞ dB.
5 Press the MIX MINUS OWNER button.
The “MIX MINUS OWNER popup window”(p.333) appears.
6 Select the OWNER channel.
330
System Setup > Mix minus