User Manual

SURROUND PAN 1CH screen
When the bus setting in BUS SETUP is set to surround mode, the SURROUND PAN 1CH screen will appear as
follows. (The example shows PAIR)
1
2
2
7
6543
8
a
Surround graph
This shows the surround positioning.
b
Assignment buttons for each bus
By default, all buttons are on. Turn off buses that do not output an audio signal.
c
L/R knob
Specifies the left/right surround positioning. Use the screen encoder or the [TOUCH AND TURN] knob to operate this.
d
F/R knob
Specifies the front/rear surround positioning. Use the screen encoder or the [TOUCH AND TURN] knob to operate this.
e
DIV knob
Specifies the proportion of the front center signal that is sent to the left, right, and center channels. With a setting of
0, the front center signal is sent only to the left and right channels. With a setting of 50, the signal is sent equally to
the left, right, and center channels. With a setting of 100, the signal is sent only to the center channel. Use the screen
encoder or the [TOUCH AND TURN] knob to operate this.
f
LFE knob
This knob adjusts the level of the LFE (low frequency effects) channel. Use the screen encoder or the [TOUCH AND
TURN] knob to operate this.
g
SURROUND A button
Specifies whether the signal is sent to surround bus A.
340
System Setup > SURROUND PAN 1CH screen