User Manual

DUCKING
This dynamics type reduces the output by a fixed value (RANGE) when a signal greater than the
THRESHOLD level is input. This is effective if you want to lower the volume level of background music
using the KEY IN SOURCE signal.
・ KEY IN SOURCE
Selects the source of the key-in signal. In addition to SELF, the key-in signal can also be selected directly
from another channel or input patch.
f
INSERT
Two inserts are provided: Insert 1 and Insert 2. In each insert, you can insert up to four plug-ins/GEQ/PEQ/external
devices (via the I/O jacks). Each insert point can be selected independently for INSERT 1 and INSERT 2.
g
DELAY
Up to 1000 msec of delay is provided on each channel. You can freely select the delay insert point. You can select the
delay time unit from the following: meter, feet, sample, msec, frame, depending on your application.
DIRECT OUT
To OUTPUT PATCH
ON
POST FADER
PRE FILTER
PRE EQ
PRE DYN1
POST ON
PRE FADER
PRE DYN2
CH FADER
FOLLOW
F
ADER
CH ON
FOLLOW
ON
CH DCA 1-24
FOLLOW
DCA
LEVEL
h
DIRECT OUT
(
DIRECT OUT POINT
For each channel, a variety of points can be selected as the signal that is output to direct out.
(
DIRECT OUT LEVEL
For each channel, sets the output level of direct out.
(
FOLLOW
This function enables the direct out signal to “follow” channel parameter settings (FADER/ON/DCA) regardless of
the direct out point. For example, if you want to route a signal from immediately after the HA to the direct out for
recording, you can make the direct out signal follow the channel OFF setting to avoid possible noise caused by
connecting or disconnecting cables or turning phantom power on or off.
356
Patching > Input channel mixing engine section