User Manual

e
SHOW PORT button
Enables you to select the ports that are displayed in the grid from A, B, and A+B.
f
Continuous Patch
button
Press the continuous patch
button, and then rotate the select knob to in the upper right to patch the
intersecting channels continuously. If you press the continuous patch
button, the button and the
button will appear. Press the button again to confirm the selected continuous patches. Press the button to
revert the continuous patches to their previous state.
g
CLEAR ALL button
Press this button to clear all patches.
h
HA INFO button
When modifying an input patch, you can select whether the HA settings of the patched port will be used as-is (TAKE
FROM PORT), or whether the HA settings of the channel will be copied to the patched port (TAKE FROM CHANNEL).
When the TAKE FROM CHANNEL button is selected, the HA settings below will be copied from the channel side to the
patched port. The default settings will be used when patching a (non-HA) input that does not have these settings to
an input channel.
HA settings and defaults
HA gain (-6 dB)
HPF ON/OFF (OFF)
+48V ON/OFF (OFF)
GC ON/OFF (OFF)
φON/OFF (OFF)
HPF frequency (80 Hz)
SILK ON/OFF (OFF)
SILK RED/BLUE (RED)
SILK (0.0)
M/S ON/OFF (OFF)
M/S S-GAIN (STEREO)
364
Patching > INPUT patch window