User Manual

Pair setting
You can pair adjacent odd/even MIX buses (in that order), and use them as a stereo module.
BUS TYPE
MIX buses can be either the FIXED type whose send level is fixed or the VARI type whose send level is variable;
you can switch each odd/even-numbered pair to either type.
Library
The “OUTPUT CHANNEL LIBRARY” lets you store and recall various output channel parameters.
MATRIX bus
ON
MATRIX1-36
HPF
LPF
8 BAND
PEQ
DELAY
Max.1000ms
LEVEL/
DCA1-24
To OUTPUT PATCH
DIMMER
TALKBACK
KEY IN
DYNAMICS
INSERT 1
PLUG-IN 1
PLUG-IN 2
PLUG-IN 3
PLUG-IN 4
INSERT 2
PLUG-IN 1
PLUG-IN 2
PLUG-IN 3
PLUG-IN 4
INSERT 1
INSERT 2
POST
ON
PRE
FILTER
PRE
EQ
PRE
DYN
PRE
DELAY
POST
FADER
1
4
2
3 5
One of them can be selected.
a
FILTER
(
HPF
The slope of the high-pass filter can be specified as -6 dB/oct, -12 dB/oct, -18 dB/oct, and -24 dB/oct.
(
LPF
The slope of the low-pass filter can be specified as -6 dB/oct or -12 dB/oct.
b
EQ
This is an eight-band parametric EQ.
(
8 BAND PEQ
The following EQ types can be selected: PRECISE, AGGRESSIVE, SMOOTH, or LEGACY. Two sets of EQ parameter
settings (A and B) can be saved for convenient comparison. The FREQUENCY parameter of each band is normally
set in 1/12 octave steps, but if you need more precise adjustment, you can set it in 1/24 octave steps. The two
bands LOW and HIGH can be switched to L SHELF (Low Shelving) and H SHELF (High Shelving) respectively.
The selectable EQ types are the same as for input channels (“Input channel mixing engine section”(p.354)).
c
DYNAMICS
One dynamics processor module is provided. You can select a dynamics function from six types, including GATE and
COMP. Two types of compressor are provided: LEGACY COMP and COMP 260. Two sets of dynamics parameter
settings (A and B) can be saved for convenient comparison.
The selectable EQ types are the same as for input channels (“Input channel mixing engine section”(p.354)).
367
Patching > Output channel mixing engine section