User Manual

・ KEY IN SOURCE
Selects the source of the key-in signal. In addition to SELF, the key-in signal can also be selected directly
from another channel or input patch. You can use an HPF, BPF, or LPF as a KEY IN FILTER.
d
INSERT
Two inserts are provided: Insert 1 and Insert 2. In each insert, you can insert up to four plug-ins/GEQ/PEQ/external
devices (via the I/O jacks). Any insert point can be selected independently for INSERT 1 and INSERT 2.
e
DELAY
Up to 1000 msec of delay is provided on each channel. You can freely select the delay insert point. You can select the
delay time unit from the following: meter, feet, sample, msec, frame, depending on your application.
Pair setting
Adjacent channels can be paired and used as a stereo module. Adjacent odd/even MATRIX buses (in that
order) can be specified as a pair.
Library
The “OUTPUT CHANNEL LIBRARY” lets you store and recall various input channel parameters.
BUS TYPE
MATRIX buses are only VARI type.
STEREO bus
ON
BALANCE
STEREO A/B
L R
LEVEL/
DCA1-24
To
OUTPUT
PATCH
To
OUTPUT
PATCH
DIMMER
TALKBACK
INSERT 1
PLUG-IN 1
PLUG-IN 2
PLUG-IN 3
PLUG-IN 4
INSERT 2
PLUG-IN 1
PLUG-IN 2
PLUG-IN 3
PLUG-IN 4
HPF LPF
8 BAND
PEQ
DELAY
Max.1000ms
DYN
AMICS
INSERT 1
INSERT 2
POST
ON
PRE
FILTER
PRE
EQ
PRE
DYN
PRE
DELAY
POST
FADER
4
1
2 3 5
DIMMER
TALKBACK
KEY IN
One of them can be selected.
a
FILTER
(
HPF
The slope of the high-pass filter can be specified as -6 dB/oct, -12 dB/oct, -18 dB/oct, and -24 dB/oct.
(
LPF
The slope of the low-pass filter can be specified as -6 dB/oct or -12 dB/oct.
368
Patching > Output channel mixing engine section