User Manual

b
EQ
This is an eight-band parametric EQ.
(
8 BAND PEQ
The following EQ types can be selected: PRECISE, AGGRESSIVE, SMOOTH, or LEGACY. Two sets of EQ parameter
settings (A and B) can be saved for convenient comparison. The FREQUENCY parameter of each band is normally
set in 1/12 octave steps, but if you need more precise adjustment, you can set it in 1/24 octave steps. The two
bands LOW and HIGH can be switched to L SHELF (Low Shelving) and H SHELF (High Shelving) respectively.
The selectable EQ types are the same as for input channels (“Input channel mixing engine section”(p.354)).
c
DYNAMICS
One dynamics processor module is provided. You can select a dynamics function from six types, including GATE and
COMP. Two types of compressor are provided: LEGACY COMP and COMP 260. Two sets of dynamics parameter
settings (A and B) can be saved for convenient comparison.
The selectable EQ types are the same as for input channels (“Input channel mixing engine section”(p.354)).
d
INSERT
Two inserts are provided: Insert 1 and Insert 2. In each insert, you can insert up to four plug-ins/GEQ/PEQ/external
devices (via the I/O jacks). Any insert point can be selected independently for INSERT 1 and INSERT 2.
e
DELAY
Up to 1000 msec of delay is provided on each channel. You can freely select the delay insert point. You can select the
delay time unit from the following: meter, feet, sample, msec, frame, depending on your application.
ON
BALANCE
STEREO A/B
L R
LEVEL/
DCA1-24
To
OUTPUT
PATCH
To
OUTPUT
PATCH
DIMMER
TALKBACK
STEREO
TO MATRIX
STEREO TO MATRIX
ON
LEVEL
BUS TYPE: VARI
TO MATRIX
PAN/BAL
ON
LEVEL
HPF LPF
8 BAND
PEQ
DELAY
Max.1000ms
DYNAMICS
POST
ON
PRE
FILTER
PRE
EQ
PRE
DYN
PRE
DELAY
PRE
FADER
POST
FADER
6
DIMMER
TALKBACK
KEY IN
PRE FADER
PRE FILTER
PRE EQ
PRE
DYN
POST FADER
POST ON
PRE DELAY
PRE FADER
PRE FILTER
PRE EQ
PRE
DYN
POST FADER
POST ON
PRE DELAY
f
STEREO TO MATRIX
A signal can be sent from the STEREO channel to MATRIX buses 1 – 36.
(
Send Point
This allows you to flexibly select the send point for each channel. You can set the send point selected here to PRE
or POST using the PRE button. You can select each send point on the BUS SETUP screen.
369
Patching > Output channel mixing engine section