User Manual

Patching the output ports
This section explains how to edit the output patching.
1 Press the PATCH button on the menu bar to access the PATCH screen.
2 Press the OUTPUT tab.
The “OUTPUT patch window”(p.373) appears.
3 Use the knob in the upper right to display the desired output ports.
4 Use the knob in the lower-left corner to display the output channels.
5 Press the desired grid cell to patch a desired channel.
NOTE
On the RPio622 or RPio222, the output to HY slot 2 can be patched if the routing mode is set to Mode 2. (“I/O rack settings
popup window”(p.252)) However, the routing mode setting is not included in scene data. Therefore, if you recall a scene,
you must switch to Mode 2.
372
Patching > Patching the output ports