User Manual

PORT-PORT patch window
1
2
5
6
4
3
This screen contains the following items.
a
DISPLAY MODE buttons
Press a button to switch the patch target that is shown in the patch grid. The upper line of buttons are for patching
within a slot and to the bridge, and the lower line of buttons are for bridge patching between slots.
b
Input components/slots/channels
This section shows input component and bridge information, slot numbers, and channel numbers.
c
Continuous Patch
button
Press the continuous patch
button, and then rotate the select knob to in the upper right to patch the
intersecting channels continuously. If you press the continuous patch
button, the button and the
button will appear. Press the button again to confirm the selected continuous patches. Press the button to
revert the continuous patches to their previous state.
d
Output components/slots/channels
This section shows output component and bridge information, slot numbers and channel numbers.
e
Grid
This grid lets you patch output jacks (horizontal lines) to input jacks (vertical columns). Currently patched grid cells
are shown in white. Press (or click) a desired grid cell to set or disable the patch.
f
CLEAR ALL button
Press this button to clear all selections.
380
Patching > PORT-PORT patch window