User Manual

b
Input selector
You can provide eight sources to be monitored, and switch between them. The signals of up to eight channels can be
assigned to one monitor source. You can select not only channel or bus signals, but signals directly from input
patches as monitor signals.
c
Monitor circuit structure
This consists of three channels: L-channel, R-channel, and CENTER channel.
d
DELAY
Allows the monitor signal to be delayed. You can specify up to 1000 msec. You can select the delay time unit from the
following: meter, feet, sample, msec, frame, depending on your application.
e
INSERT
A plug-in, GEQ, or PEQ can be inserted. The insert point is fixed at PRE EQ (immediately before the EQ). An insert point
is also provided for the PHONES OUT.
f
PEQ
The monitor section provides an 8-band parametric EQ specialized for monitoring.
g
MONITOR LEVEL
The MONITOR OUT L-channel, R-channel, and CENTER channel output levels can be adjusted. The monitor level can
also be assigned to a fader.
h
Output structure
(
L-channel, R-channel, and CENTER channel of MONITOR A
(
L-channel, R-channel, and CENTER channel of MONITOR B
i
DIMMER ON TALKBACK
Causes the CUE signal to interrupt the monitor output when CUE is active. The CENTER channel can be turned on/off
independently.
j
DIMMER ON TALKBACK
Attenuates the monitor signal by a fixed amount.
k
PHONES LEVEL LINK
The level of the signal sent to the PHONES A/PHONES B jacks is linked with the MONITOR A/MONITOR B LEVEL.
l
MONITOR OUT MODE
Downmixes the L/R signals to monaural. This also downmixes the L/R/C signals to L/R.
m
L R+C DOWNMIX
Allows you to downmix the L/R/C signals to L/R.
n
DIMMER ON CUE
When the CUE signal has interrupted the monitor output, this attenuates the signal that is being input to the monitor.
NOTE
Monitor assignments and on/off switching can also be assigned to a USER DEFINED key.
386
Monitor > About monitoring