User Manual

CUE OPERATION mode

About CUE OPERATION mode in Cue mode

(

CH (Channel) mode

This mode assumes only one operator will operate the system. You can specify the cue destination (CUE A,

B, and A+B) for each channel individually. You can change this destination for each channel individually by

holding down the [SHIFT] key and pressing the desired [CUE] key. (A->B->A+B->A->B->…)

(

BAY mode

This mode assumes two operators will operate the system. You can specify the cue destination (CUE A and

B) for each bay. For example, you can send the same channel signal from bay L to CUE B, and bay C to CUE

NOTE

You can also set the mode in the OPERATION MODE field in the PREFERENCES popup window (PREFERENCES popup window).

412

Monitor > CUE OPERATION mode