User Manual

e
INPUT CUE field
This field enables you to make settings related to the input channel cue.
(
Cue point select button
Sets the cue point to PRE FILTER (immediately before the filter), PRE FADER (immediately before the fader), AFL
(immediately after the fader), or POST PAN (immediately after PAN).
NOTE
Be aware that if you select POST PAN, you will be unable to monitor signals sent to the MONO bus from an input channel that
is set to LCR mode.
(
INPUT FOLLOW PAN button
If this button is on, the TO STEREO PAN setting will be applied to the pan setting of the signal sent from input
channels to the CUE bus.
(
PFL TRIM knob
Specifies the monitor levels when PFL is selected. Use the screen encoder to adjust the value.
f
DCA CUE field
This section enables you to make settings related to DCA cue.
(
Cue point select button
Sets the cue point for DCA to PRE PAN (immediately before PAN) or POST PAN (immediately after PAN).
(
DCA TRIM knob
Indicates the monitor level of cue signals from a DCA. Use the screen encoder to adjust the value.
(
UNITY button
Turn on this button to monitor signals at the same volume level that was obtained when the master level for each
DCA was set to 0 dB (unity gain).
g
OUTPUT CUE field
Enables you to make settings related to output channel cue.
(
Cue point select button
Enables you to set the cue point for the output channel to PFL (immediately before fader) or AFL (immediately
after fader).
(
PFL TRIM knob
Indicates the monitor levels when PFL is selected. Use the screen encoder to adjust the value.
h
Meters
This field indicates the output level of the cue L/R channels.
i
CUE OUT MODE select button
You can output the cue signal in stereo or monaural.
j
INSERT button
Press this button to display the window, in which you can insert plug-ins into the cue signal.
k
INSERT ON button
Switches the plug-in insert on or off. The currently-specified plug-ins are displayed to the left of the INSERT ON
button.
418
Monitor > CUE popup window