User Manual

Using the oscillators
You can send a sine wave or pink noise from the internal oscillator to a desired bus.
1 Press the MONITOR button on the menu bar.
The “MONITOR screen (oscillator)”(p.429) appears. The OSCILLATOR field in the MONITOR
screen lets you check the current oscillator settings, and turn the oscillator on or off.
If you want to view or edit the oscillator settings in greater detail, use the OSCILLATOR popup
window described in step 2 and subsequent steps.
2 Press the OSCILLATOR popup button or the ASSIGN field.
The “OSCILLATOR popup window”(p.430) appears. In this popup window, you can make
detailed settings for the oscillator.
3 Press a button in the MODE field to select the type of signal you want to output.
4 Use the knobs and buttons in the parameter field to adjust the oscillator
parameters.
The displayed parameters will vary depending on the oscillator selected in the MODE field. To
control the knobs shown in the parameter field, use the corresponding screen encoders.
5 Press a button in the ASSIGN field to specify the input channel(s) or bus(es) to
which the oscillator signal will be sent (multiple selections are allowed).
The buttons correspond to the following buses. (“Destination of oscillator signals”(p.428))
6 To enable the oscillator, press the OUTPUT button to turn it on.
The oscillator signal will be sent to the input channel or bus you selected in step 5. When you
press the button again, the oscillator will turn off.
NOTE
You can also assign oscillator on/off or an ASSIGN change to a USER DEFINED key (USER DEFINED keys).
427
Monitor > Using the oscillators