User Manual

MONITOR screen (oscillator)
1 5
2 3 4
This screen contains the following items.
a
OSCILLATOR popup button
Enables you to access the OSCILLATOR popup window, in which you can make detailed oscillator settings.
b
OSCILLATOR LEVEL field
Adjusts the level of the oscillator. A meter beside the LEVEL knob indicates the output level of the oscillator. If
OSCILLATOR MODE is set to SINE WAVE, the frequency of the oscillator is shown. Press the LEVEL knob to adjust the
oscillator level using the corresponding screen encoder. The range is –96.00 dB to 0.00 dB.
c
OSCILLATOR MODE field
Indicates the selected oscillator mode. Pressing the MODE button repeatedly will switch modes.
(
SINE WAVE
(
SINE WAVE 2CH
(
PINK NOISE
(
BURST NOISE
d
OSCILLATOR ASSIGN field
An indicator lights to indicate the currently-selected oscillator output destination (input channels, buses or monitor).
Use the buttons at the left to switch the indicators. A green “ASSIGNED” indicator lights up on buttons that contain a
channel/bus selection. Press this field to open the OSCILLATOR popup window, in which you can assign the oscillator
output to buses.
e
OSCILLATOR OUTPUT button
Turns the oscillator output on or off.
429
Monitor > MONITOR screen (oscillator)