User Manual

(
LEVEL knob, HPF knob, LPF knob
These are the same as for the PINK NOISE mode.
(
WIDTH knob
Indicates the length of noise being output intermittently. Use the screen encoder to adjust the value.
(
INTERVAL knob
Indicates the length of silence between noise bursts. Use the screen encoder to adjust the value.
INTERVAL
WIDTH
Level
Pink noise output
Time
The BURST NOISE button is turned on.
c
ASSIGN section
Enables you to select a channel to which the oscillator signal will be sent. Press one of the five tabs below to select
the type of channels/buses displayed, and then press the button(s) for the desired channels/buses (multiple
selections are allowed). If SINE WAVE 2CH mode is selected, output signals will vary depending on whether the
selected channel number is odd or even. For example, the odd-channel signal will be routed to MIX1 and the even-
channel signal will be routed to MIX2. You can press the CLEAR ALL button to defeat all selections.
d
Channel display select buttons
Select the type of channels that you want to view on screen. Available options are CH1-72, CH73-144, MIX, ST/MTRX,
and MONITOR. (The number of channels varies depending on the connected DSP engine.) A green “ASSIGNED”
indicator lights up on buttons that contain a channel/bus selection.
e
Meter section
Indicates the oscillator output level.
f
OSCILLATOR OUTPUT button
Turns the oscillator on or off. If this button is turned on, the oscillator signal will be sent to the input channel or bus
you selected in the ASSIGN section. When you press the button again, the oscillator will turn off.
g
CLEAR ALL button
Excludes all output channels from the oscillator signal destination.
h
CLOSE button
Closes the OSCILLATOR popup window.
432
Monitor > OSCILLATOR popup window