User Manual

8 When you finish making settings, press the CLOSE button to close the popup
window.
9 Repeat steps 6–8 to assign the buses to other DEFINE buttons, as needed.
10 Select a DEFINE that you want to use for talkback, using DEFINE buttons in the
TALK GROUPS field on the MONITOR screen or in the TALK GROUPS field in the
TALKBACK SETTINGS popup window.
11 To enable talkback, press the TALKBACK ON button to turn it on.
The TALKBACK ON button will alternately turn on or off each time you press the button (Latch
operation). While talkback is on, signals from the TALKBACK jack and the selected INPUT jack
will be output to the destination buses.
NOTE
(
You can also assign talkback on/off or an ASSIGN change to a USER DEFINED key. In this case, you can select either a
Latch operation or an Unlatch operation (the function will be enabled only while you continue holding down the key)
(USER DEFINED keys).
(
You can also use the DIMMER ON TALKBACK function to attenuate the monitor level of the non-talkback signals while
talkback is on (“MONITOR SETTINGS popup window”(p.393)).
436
Monitor > Using talkback