User Manual

Controlling the EQ via the Selected Channel section (CS-
R10, CSR10- S, CSD-R7)
1 Select the channel that you want to operate.
Four-band EQ (HIGH, HIGH MID, LOW MID, LOW) is provided on all input channels. Eight-band
EQ is provided on all output channels. (Control is divided into [1-4] and [5-8] groups of four
bands each.)
2 If you selected an output channel in step 1, use the [1-4]/[(5-8)] keys in the Selected
Channel section to select the [1-4]/[(5-8)] group of four bands.
3 Use the [Q] knob (EQUALIZER section e), [FREQUENCY] knob (EQUALIZER section
f), and [GAIN] knob (EQUALIZER section g) for each band in the Selected Channel
section to set the Q, center frequency, and gain for each band.
NOTE
(
Pressing the [FREQUENCY] knob and the [GAIN] knob simultaneously enables you to bypass the corresponding band.
(
Pressing the [Q] knob and the [GAIN] knob simultaneously enables you to reset the boost/cut amount of the
corresponding band to 0 dB.
(
If you want to use the LOW band as a shelving-type EQ, press the band 1 [Q] knob and band 1 [FREQUENCY] knob
simultaneously. If you want to use the HIGH band as a shelving-type EQ for input channels, press the band 4 [Q] knob
and band 4 [FREQUENCY] knob simultaneously. For output channels, press the band 8 [Q] knob and band 8
[FREQUENCY] knob simultaneously.
4 If you want to restore the EQ of the currently-operated channel to a flat state,
simultaneously press the [1-4] and [(5-8)] keys in the Selected Channel section.
When you press these two keys simultaneously, the boost/cut amount of all bands will be
reset to 0 dB.
5 If you want to use the HIGH band or LOW band as a shelving-type EQ, turn on the
[SHELF] key for the corresponding band.
477
CH Parameter > Controlling the EQ via the Selected Channel section (CS-R10, CSR10- S, CSD-R7)