User Manual

g
Dynamics processor type button
Enables you to select the dynamics processor type from the following: LEGACY COMP, COMP260, GATE, DE-ESSER,
EXPANDER, DUCKING.
h
A/B switch buttons
Enable you to switch between A and B as the storing destination for the dynamics parameters.
i
Dynamics graph
Displays the input/output response of the dynamics processors.
j
DYNAMICS ON/OFF button
Switches the dynamics processor on or off.
k
Dynamics IN/OUT level meters, GR meter
These meters indicate the peak level of the signals before and after the dynamics processing, and the amount of gain
reduction. For a stereo channel, these meters indicate the level of both the L and R channels.
l
KEY IN SOURCE select button
Enables you to select one of the following as the key-in signal that will trigger dynamics processing.
(
SELF PRE EQ ..............The pre-EQ signal of the same channel
(
SELF POST EQ ..............The post-EQ signal of the same channel
(
OTHER PRE EQ ..............The signal immediately after the EQ of other input or output channels Press this button
to access a window in which you can select a signal.
(
DIRECT INPUT ..............Press this button to access the INPUT PATCH window that enables you to select the key-
in signal.
497
CH Parameter > DYNAMICS 1/2 popup window (1CH)