User Manual
Using SENDS TO
By using SENDS TO, you can specify the sends to a specific MIX or MATRIX bus for 12 channels at a time.
1 Press the [VIEW] key to access the OVERVIEW screen.
2 Use the MIX/MATRIX SENDS [MIX]/[MATRIX] keys to switch the type of send-
destination bus.
3 Use the MIX/MATRIX SENDS [1-12]/[13-24]/[25-36]/[37-48]/[49-60]/[61-72] keys to
select a bank of send-destination buses.
NOTE
Press the [SHIFT] key to display the bank select buttons in the DCA/mute group field. Use these buttons to select a bank for
the send destination bus.
4 Select the SEND knob of the corresponding send-destination MIX/MATRIX bus, and
press it again to access the “SENDS TO popup window”(p.537).
NOTE
When MATRIX channels are selected, pressing the SEND knob again will access the “SENDS FROM popup window”(p.539).
5 You can use the SEND ON button to turn on/off the signal that is sent from each
input or MIX channel to the currently-selected MIX/MATRIX bus.
6 If necessary, use the PRE button to select the send point of the signal that is sent
from each input channel, MIX channel, or STEREO channel to a VARI-type MIX bus or
MATRIX bus.
531
CH Parameter > Using SENDS TO