User Manual

Using SENDS FROM
By using SENDS FROM, you can specify the sends from a specific channel to the MIX or MATRIX buses for 12
channels at a time.
1 Press the [VIEW] key to access the OVERVIEW screen.
2 Press the MIX popup button or the MATRIX popup button.
The SENDS FROM popup window appears.
3 Use the SEND ON button to switch on/off the signal that is sent from the currently-
selected channel to the MIX or MATRIX bus.
4 If necessary, use the PRE button to select the send point of the signal that is sent to
the MIX or MATRIX bus.
NOTE
(
This allows you to flexibly select the send point for each channel (see SEND POINT (INPUT) on page 142).
(
The PRE button is not shown for a FIXED-type MIX bus.
533
CH Parameter > Using SENDS FROM