User Manual

Using the Selected Channel section to make send level
settings(CS-R10, CSR10- S, CSD-R7)
You can use the knobs of the Selected Channel section to adjust the send levels.
1 Verify that an output port is assigned to the MIX/MATRIX bus to which the signal is
sent, and that the corresponding output port is connected to the monitor system
or an external effect processor.
2 Use the top panel [SEL] keys to select the channel that will send a signal to the MIX/
MATRIX bus.
3 Press the MIX/MATRIX SENDS [PRE] key to switch the send point to PRE or POST.
NOTE
If the send destination is set to FIXED, the MIX/MATRIX SENDS [PRE] key is unavailable.
4 Press the MIX/MATRIX SENDS [ON] key to turn it on.
5 Use the MIX/MATRIX SENDS knobs of the Selected Channel section to adjust the
send levels to the MIX/MATRIX buses.
NOTE
(
If the send-destination bus is stereo, the left knob adjusts the pan/balance and the right knob adjusts the send level.
(
To monitor the signal that is being sent to a specific MIX/MATRIX bus, recall the corresponding MIX/MATRIX channel and
press the corresponding [CUE] key.
6 Use the top panel [SEL] keys to switch channels, and adjust the send levels to all
MIX/MATRIX buses in the same way.
536
CH Parameter > Using the Selected Channel section to make send level settings(CS-R10, CSR10- S, CSD-R7)