User Manual

SENDS TO popup window
3
5
4
6
9
8
7
1 2
This screen contains the following items.
a
ALL PRE button
Sets the send point to “PRE” for all send sources (input channels, MIX channels, STEREO channels) of the selected
send destination. At this time, the PRE button (5) will light up.
b
ALL POST button
Sets the send point to “POST” for all send sources (input channels, MIX channels, STEREO channels) of the selected
send destination. At this time, the PRE button goes dark.
c
Send destination select button
Indicates the currently-selected send destination. You can use the –/+ buttons at left and right to switch to adjacent
channels. You can use the << / >> buttons to switch in steps of 12 channels.
NOTE
Use the [MIX]/[MATRIX] keys to switch the send-destination selection. You can also switch this by holding down the [SHIFT] key
and pressing the meter area display section.
d
Channel select buttons
Indicate the send-source channel being controlled. Press this button to select the on-screen selected channel. The
current channel icon, number, and color appear on the button, and the channel name appears below the button.
NOTE
You can use the layer select keys to switch the send-source selection.
e
PRE button
Switches the send point to PRE or POST for each send-source channel. If a button is lit, the send point is set to PRE.
537
CH Parameter > SENDS TO popup window