User Manual

SENDS FROM popup window
1
3
4
6
7
2
5
This screen contains the following items.
a
Send-source select button
Indicates the currently-selected send source. You can use the –/+ buttons at left and right to switch to adjacent
channels. You can use the << / >> buttons to switch in steps of 12 channels. This indication is linked with the on-
screen selected channel.
b
Bus indication
Shows the send-destination bus. Use the [MIX]/[MATRIX] keys to switch the send-destination selection. You can also
switch this by holding down the [SHIFT] key and pressing the meter area display section.
c
PRE button
Selects either PRE or POST as the send point of the signal that is sent to each bus. If a button is lit, the send point is
set to PRE.
d
SEND ON button
This button switches send to each bus on/off.
e
FOLLOW setting buttons
Enable you to set parameters for signals routed from input channels to the MIX/MATRIX bus so that the parameters
will follow the FADER/ON/DCA settings.
f
SEND PAN/BALANCE knob
Adjusts the pan/balance when the send-destination bus is stereo. If the bus is monaural or is set to FIXED, this knob
will not be shown. If the send source is monaural, the knob adjusts pan. If the send source is stereo, the knob adjusts
balance.
539
CH Parameter > SENDS FROM popup window