User Manual

SEND / USER DEFINED knob

Adjusts the send level for the corresponding bus while the SEND function is enabled. Enables you to control the

assigned function while the USER DEFINED KNOB function is enabled.

1 Verify that an output port is assigned to the MIX/MATRIX bus to which the signal is

sent, and that the corresponding output port is connected to the monitor system

or an external effect processor.

2 Use the top panel [SEL] keys to select the channel that will send a signal to the MIX/

MATRIX bus.

3 Press the [ASSIGN] key.

The “SENDS/USER DEFINED KNOB popup window”(p.546) appears.

4 Select a MIX/MATRIX bus to which the signal will be sent.

5 Use the SEND/USER DEFINED knob to adjust the level to send to the MIX/MATRIX

bus.

6 Use the top panel [SEL] keys to switch channels, and adjust the send levels to all

MIX/MATRIX buses in the same way.

545

CH Parameter > Using the Touch Screen section to make send level settings (CS-R5, CS-R3)