User Manual

Controlling via the TO STEREO section
The TO STEREO buses are used for outputting signals to the main speakers.
1 Verify that an input source is connected to the channel that you are controlling,
and set the head amp’s phantom power, gain, and phase to obtain the optimal
input signal.
2 Press the TO STEREO field knob in the OVERVIEW screen of the input channel or MIX
channel whose signal you want to send to the STEREO A bus and STEREO B bus, or
press the knob in the TO STEREO field of the SELECTED CHANNEL VIEW screen.
TheTO STEREO popup windowappears.
3 Use the ST/LCR mode select button to select either ST mode or LCR mode for each
channel.
4 In the channel strip section of the top panel, verify that the [ON] key is turned on
for the input channel or MIX channel that you want to operate, and then raise the
fader to an appropriate position.
5 Press the top panel TO ST [A]/[B] key to turn it on.
6 In the channel strip section of the top panel, verify that the [ON] key is turned on
for the STEREO channel that you want to operate, and then raise the fader to an
appropriate position.
555
CH Parameter > Controlling via the TO STEREO section