User Manual

ST mode and LCR mode
The STEREO buses are used for outputting signals to the main speakers. Signals can be sent to a STEREO bus
in one of two modes, ST mode or LCR mode, and you can make this selection individually for each channel.
These modes differ in the following ways.
ST mode
This method allows an input channel or MIX channel to individually send independent signals to the STEREO
A bus and STEREO B bus.
(
The signals sent to the STEREO A bus and STEREO B bus can be switched on or off individually.
(
The pan of the signal sent from the input channel or MIX channel to L/R of the STEREO A bus or STEREO B
bus is controlled by the TO ST PAN knob.
About MONO
By using the L/R PATH pull-down menu in the SELECTED CHANNEL VIEW screen, STEREO B can be set to
MONO. If it is set to MONO, the same signal will be output to L and R of STEREO B.
L/R PATH pull-down menu in the
SELECTED CHANNEL VIEW screen
L/R PATH pull-down menu in the SELECTED CHANNEL VIEW screen
LCR mode
This method allows an input channel or MIX channel to send its signals to the three buses: STEREO A (L and
R) and STEREO B (C) simultaneously.
(
The signals sent to the STEREO A bus and STEREO B bus can be switched on/off together.
(
The level difference between the signals sent from the input channel or MIX channel to the STEREO A (L
and R) buses and to the STEREO B (C) bus is controlled by the CSR (center/side ratio) knob.
(
The level of the signal sent from the input channel or MIX channel to the STEREO A (L and R) buses and the
STEREO B (C) bus will change according to the settings of the TO ST PAN knob and the BALANCE knob.
557
CH Parameter > ST mode and LCR mode