User Manual

Sending a signal to a STEREO bus
1 Verify that an input source is connected to the channel that you are controlling,
and set the head amp’s phantom power, gain, and phase to obtain the optimal
input signal.
2 Access the TO STEREO popup window, either by pressing the TO STEREO field knob
in the OVERVIEW screen of the input channel or MIX channel whose signal you want
to send to the STEREO A bus and STEREO B bus, or by pressing the knob in the TO
STEREO field of the SELECTED CHANNEL VIEW screen.
TO STEREO field in the
OVERVIEW screen
TO STEREO field in the SELECTED
CHANNEL VIEW screen
The TO STEREO popup window appears.
3 Use the ST/LCR mode select button to select either ST mode or LCR mode for each
channel.
4 n the channel strip section of the top panel, verify that the [ON] key is turned on
for the input channel or MIX channel that you want to operate, and then raise the
fader to an appropriate position.
5 Press the top panel TO ST [A]/[B] key to turn it on.
559
CH Parameter > Sending a signal to a STEREO bus