User Manual

f
∑ clipping indicator
This indicator lights to indicate that a signal is clipping at some point in the channel.
NOTE
This is also shown for MATRIX channels that do not have a stereo send
If the ST/LCR mode select button is set to LCR mode, the following button and knob will be shown instead of the TO
ST A button (c) and TO ST B button (d).
7
8
g
LCR button
Switches on/off all signals sent from the channel to the STEREO bus. If this button is off, the corresponding channel
will send no signals to the STEREO bus.
h
CSR knob
Adjusts the ratio of the signal level sent from the channel to the STEREO A (L and R) buses and the signal level sent to
the STEREO B (C) bus, in a range of 0–100%. To edit a value, press a knob to select it, and then use the corresponding
screen encoder.
In the case of a MIX channel, the following pull-down menu is shown above the ST/LCR select button.
9
i
TO STEREO send point
Enables you to select the send point as PRE FILTER, PRE EQ, PRE DYNA, PRE DELAY, PRE FADER, or POST FADER.
In the case of a STEREO bus MIX channel, the following button is displayed.
562
CH Parameter > TO STEREO popup window