User Manual

Parameters to be copied
The parameters to be copied are shown below.
Parameter Description
NAME Channel name, color, icon
ANALOG GAIN
Gain, phantom power on/off, GANG, gain compensation, M/S
decode
SILK SILK settings
PHASE Ø
DIGITAL GAIN Gain, GANG
HPF/LPF On/off, cutoff frequency, type
EQ On/off, type, attenuator, band settings
DYNA 1
DYNA 2
On/off, type, type parameter, key-in (filter, Q, cutoff
frequency)
INSERT 1
INSERT 2
On/off, point
MIX SEND Level, PRE/POST, FOLLOW settings
MATRIX SEND Level, PRE/POST, FOLLOW settings
DIRECT OUT On/off, level, point, FOLLOW settings
DELAY On/off, delay time, point, GANG
FADER Level
CH ON On/off
MIX ON On/off
MATRIX ON On/off
SURR Surround settings (on/off, positioning, DIV, LFE)
TO STEREO
TO STEREO settings (on/off, mode, point
*1
, PAN, BALANCE,
CSR)
DCA ASSIGN DCA assign settings
MUTE ASSIGN Mute assign settings
*1: Output channels only
Settings will be made as follows when the pair setting for the copy source channel and for the copy
destination channel differs, in the case where the WITH PLUGINS button is on and plugins are included.
Copy source is a mono channel, and copy destination is a mono channel
Copy source Copy destination
31BandGEQ
Copy source will be copied and patched (On, Band/Gain,
Limit)
Flex15GEQ
Copy source will be copied and patched (On, Band/Gain,
Limit)
8BandPEQ
Copy source will be copied and patched (On, Type, Band/
Gain, Band/Q, Band/Bypass, Band/Freq., Low Shel., High
Shel.)
602
Channel Job > Parameters to be copied