User Manual

Copy source Copy destination
Effect
When the copy source is a Stereo type, replace with Dual
type, and copy and patch (including the parameters and
bypass). When the copy source is a Normal type
*1
, copy and
patch the L side (including the parameters and bypass).
BLANK
Clear the copy destination insert module patch (leave the
DSP allocation used by the copy destination)
*1: Except for Dual type and Stereo type
Copy source is a mono channel, and copy destination is a stereo (pair) channel
*1: The GEQ link settings for the copy destination will not be changed.
Copy source Copy destination
31BandGEQ
Copy source will be copied and patched to the L and R sides
(On, Band/Gain, Limit)
*1
Flex15GEQ
Copy source will be copied and patched to the L and R sides
(On, Band/Gain, Limit)
*1
8BandPEQ
Copy source will be copied and patched to the L and R sides
(On, Type, Band/Gain, Band/Q, Band/Bypass, Band/Freq.,
Low Shel., High Shel.)
*1
AutoMixer
Two open channels will be assigned (parameters will not be
copied)
OutBoard Copy destination is changed to OutBoard (no patching)
Effect
When the copy source is a Dual type, replace with Stereo
type, and copy and patch (including the parameters and
bypass). When the copy source is a Normal type
*2
, 1-in/1-out
and 1-in/2-out effects will not be copied. The effect will be
BLANK. Everything else will be copied and patched to the L
and R sides (including parameters and bypasses).
BLANK
Clear the copy destination insert module (leave the DSP
allocation used by the copy destination)
*2: Except for Dual type and Stereo type
NOTE
An alert screen will be displayed when copying if a mount or patch operation using the PM Editor or other means cannot be
performed, or when there are insufficient resources.
604
Channel Job > Parameters to be copied