User Manual

g
RTA button
If this button is on, a semi-opaque frequency analysis graph of the input signal (immediately after EQ) will be
superimposed on top of the EQ frequency response graph.
h
PEAK HOLD
If this button is on, the analyzed frequency response graph will hold the peak level indication.
i
HOLD button
If this button is on, the frequency response graph will indicate and hold the result of the frequency analysis.
j
BALLISTICS field
(
BALLISTICS button
If this button is on, you will be able to add rate of decay to the analyzed frequency response graph.
(
AST/SLOW switch button
Switches the decay rate of graph rendering (FAST/SLOW).
k
Fader
This fader indicates the boost/cut amounts for each band of the 31-band GEQ. You can check the actual values shown
in the numerical boxes below. You can control the faders (that have been selected for operation on the touch screen)
by using the screen encoder or the [TOUCH AND TURN] knob.
l
FADER ASSIGN field
In this field you can select the group of bands that will be controlled by the faders in the Channel Strip section.
m
LIMIT select buttons
Enable you to select the range of gain adjustment from the following options: ±15 dB, ±12 dB, ±6 dB (these are valid in
both the boost and cut directions), or –24 dB (valid only in the cut direction).
n
LIBRARY button
Press this button to open the GEQ library window.
o
DEFAULT button
Press this button to restore the default parameter setting.
p
COPY button
Copies the selected GEQ settings to buffer memory.
q
PASTE button
Press this button to paste the settings that were copied in buffer memory to the current GEQ. If valid data has not
been copied into buffer memory, you will be unable to paste it.
r
COMPARE button
Press this button to switch between the current GEQ settings and the data in buffer memory. If valid data has not
been copied into buffer memory, you will be unable to compare the data.
622
GEQ/PEQ/Automixer > GEQ/PEQ EDIT screen