User Manual

4 Raise the corresponding fader of the Channel Strip section.
For each of a Flex15GEQ’s two GEQ units (A and B), a maximum of fifteen bands can be
controlled. The real-time number of additional bands that can be controlled is shown to the
right of “AVAILABLE BANDS" in the FADER ASSIGN field. If you have used all fifteen bands, you
will have to return one of these bands to the flat position before you can operate any other
band.
NOTE
(
The [ON] key will light if you raise or lower a fader even the slightest amount. This indicates that the corresponding band
is being modified.
(
To quickly return a boosted or cut band to the flat position, press the corresponding [ON] key in the Channel Strip
section to make it go dark.
5 Repeat steps 3 and 4 to adjust up to fifteen bands.
NOTE
If you switch the touch screen display to a different screen or to the GEQ window, the fader assignments in the Channel
Strip section will forcibly be defeated. However, if you once again display the same GEQ, the group of bands you had
previously been controlling will automatically be assigned to the faders.
6 When you finish making settings, turn off the buttons in the FADER ASSIGN field.
The faders and [ON] keys in the Channel Strip section will return to their previous function.
NOTE
When you close the GEQ popup window, the buttons in the FADER ASSIGN field automatically turn off.
624
GEQ/PEQ/Automixer > Using the Flex15GEQ